Hello. The relay module controls the 220V fluorescent lamp in Arduino. It has been confirmed that the lamp also operates whenever the relay module is switched on and off. But I want to put in a fuse holder because I want to control it while preventing overcurrent more safely, Is it okay to connect the circuit like this?? I'm currently using an Arduino unit3 compatible board. Below is the code used. void setup() { // put your setup code here, to run once: pinMode(9, OUTPUT); } void
Safety concerns about generic Arduino relay modules - Project Guidance - Arduino Forum
Safety concerns about generic Arduino relay modules - Project Guidance - Arduino Forum
Switch hookup with relay (arduino)
Relay Interface With Arduino
Buy Relay module 4 channels with optoisolation - Botland - Robotic Shop
Buy Relays module, 8 channels with opto-isolation Botland - Robotic Shop
Relay stopped working after connecting lamp to it - Motors, Mechanics, Power and CNC - Arduino Forum
Safely using a relay - General Electronics - Arduino Forum
Relay control of 220v 150w fan - General Electronics - Arduino Forum